QUICK START GUIDE
YOUR BOARD CAN LOSE POWER AND BRAKES AT ANY
MOMENT due to radio interference, a dead remote battery,
unintentional release of the Engage Button, downhill overcharging
of a full battery, and other factors. If this happens, the board turns
back into an unpowered skateboard, so only ride your Boosted
board at speeds and on hills where you’d be comfortable without
power and brakes.
BRAKING DOWNHILL ON A FULL BATTERY WILL CAUSE
BOARD SHUTDOWN since the regenerative braking will
overcharge the battery. To prevent this from happening, the
remote will warn you by beeping, and you’ll lose your braking
power. Safely come to a stop before this happens, and ride on flats
or uphill to drain the battery before attempting downhill again.
THE THROTTLE IN EXPERT AND PRO MODE IS EXTREMELY
SENSITIVE to make the board responsive and fun, but it also
means fast or sudden inputs can easily cause you to fall off. Start
by trying to move forward as slowly as possible in these modes.
HILLS AND HIGH SPEED CAN BE VERY DANGEROUS because
crashes can cause serious injuries, or worse. Be extra careful when
pushing the limits of the board, even if you’re an experienced rider.
CARS AND OTHER VEHICLES CAN KILL YOU, so always be
aware of your surroundings when riding in the presence of other
vehicles. Ride defensively and assume other vehicles can’t see you.
Remember that your board may lose power and brakes at any
moment. Be aware of the laws that govern the use of your board
on public roads, bike paths, sidewalks, or other places that you
ALWAYS WEAR A HELMET. Other safety gear, like gloves, pads,
and long sleeves is highly recommended.
DO NOT RIDE WITHOUT READING THIS MESSAGE
Whenever you ride a Boosted board, you risk death or serious
injury from loss of control, collisions, and falls. To ride safely, you
must read and follow all warnings and instructions in the manual.
ALWAYS WEAR A HELMET WHEN RIDING! Avoid water, wet surfaces,
slippery or uneven surfaces, steep hills, traffic, cracks, train
tracks, gravel, rocks, or any obstacles that could cause a loss
of traction. Avoid night riding, areas with poor visibility, and
WARNING: Do not ride a Boosted board in environments, on
inclines, or at speeds where you would not be safely in control of
an unpowered skateboard. In the event of wireless interference or
battery fault, you may need to rely on skating techniques, like foot
braking or sliding to stop.
WARNING: AVOID WATER!
Your Boosted board is not waterproof, and riding on
wet surfaces can cause a loss of traction. Electronics
and motors are water-resistant to avoid damage from
puddles and wet roads, but the deck, bearings, and
other components can still be damaged. Damage to
the board due to water exposure is not covered under
WARNING: PINCH POINTS
Keep fingers, hair, and clothing away from belts, motors,
wheels, and all moving parts.
WARNING: RISK OF ELECTRIC SHOCK!
Do not open or tamper with electronics housings, which
also voids the warranty.
WARNING: ALWAYS INSPECT YOUR BOARD / REV BEFORE YOU RIDE!
Check wheels, bearings, deck, and motors for signs of damage before you ride. Replace as necessary. If you ever have a concern please contact us immediately.
Be sure all screws, nuts and bolts are tight. The streets that you ride on will cause excessive vibration and it is possible for these items to loosen over time, so check regularly.
Please ride responsibly and respect those around you, both for
your safety and to help promote a new mode of transportation.
If you ever have any questions do not hesitate reach out to us: firstname.lastname@example.org and we will do our best to respond ASAP.